Heated Fiberglass & Carbon Composite Molds

About Heated Fiberglass and Carbon Composite Molds

TACG offers a B-staged supported film that can be used for heating composite and metal tooling.

The heater requires a heat cure and electrical insulation from carbon fiber laminates and metal surfaces. The TACG heater can be applied in 3 ways:

  • Interlaminar heater cured within supporting laminates
  • Heater which is cured to an existing composite tool
  • Application to metal tool surfaces

Request More Information


Carbon FiberFiberglassAramidMetal (attached to)

Prepreg laminates – Oven curedPrepreg laminates – Autoclave curedVARTM/RTM/Vacuum Infusion – Heat CuredVARTM/RTM/Vacuum Infusion - Room temp curedHand layupOther  

Low voltageEuropean 220VAC voltage single phaseAC voltage 3 phase